Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

7.7 HENGST ® BREATHER FILTER 2. Unsnap the filter cap and remove the spring and diaphragm insert from centrifugal filter. Remove the two assembly bolts from the breather filter assembly, and pull the breather assembly out. See Figure 7-45. 1. Filter Cap 4. Breather 2. Spring and Diaphragm 5. Assembly Bolt 3. Centrifugal Filter Figure 7-45 Hengst Filter Assembly 3. Remove the three plastic clamps holding the breather piping to the bracket. Remove the piping. See Figure 7-44. 4. Remove the two bolts from the air compressor and the block that are holding the piping bracket on. Remove the piping bracket. 5. Remove the three M8 x 35 mm bolts holding the breather filter to the timing case. 6.

Remove the two M8 x 25 mm bolts holding the breather filter to the block. 7. Remove the breather filter. 7.7.2 Installation of Hengst Filter Perform the following steps to install the Hengst filter: All information subject to change without notice. 7-56 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION