7.7 HENGST ® BREATHER FILTER 2. Install the filter assembly onto the timing case using three M8 x 35 mm bolts. Torque to 25 N·m (19 lb·ft). 1. Filter Piping 3. Hengst Filter 2. Filter Piping Bracket 4. Plastic Clamps Figure 7-47 Installation of Hengst Filter and Related Parts 3. Install the assembly to the block using two M8 x 25 mm bolts. Torque to 25 N·m (19 lb·ft). 4. Attach the temporary filter piping bracket to the air compressor and block as follows: [a] Install a M14 x 60 mm bolt with a spacer at the engine block. [b] Install a M10 x 35 mm bolt at the air compressor. [c] Torque to 60 N·m (44 lb·ft) at the air compressor and 100 N·m (74 lb·ft) torque at the block. 5.
Install pipe, connecting it at the Hengst filter mouth. 6. Install three plastic clamps at pipe bracket. See Figure 7-47. All information subject to change without notice. 7-58 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION