13.1 SCHEDULED INTERVALS [c] Screw the pre-filter element onto the separator head and tighten firmly, using hands only. NOTE: Do not use tools to tighten the pre-filter element. 8. Insert the filter element into the pre-filter housing and screw the cap onto the housing. Tighten the cap 25 N·m (18 lb·ft). 9. Tighten the drain plug. 10. Bleed the fuel system. [a] Make sure that all high-pressure lines have been tightened to 25 N·m (18 lb·ft) and all banjo bolts to 50 N·m (37 lb·ft). NOTICE: Correct torque on the high pressure lines is critical. Incorrect torques could result in leaks or lack of power due to restricted fuel flow.
[b] If equipped with a hand pump on the fuel/water separator, work the hand pump 50 times. NOTE: There should be a strong resistance in the hand pump, caused by the pressure build-up within the fuel system. All information subject to change without notice. 13-10 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION