Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

13.1 SCHEDULED INTERVALS 2. Clean the outside of the fuel filter housing. See Figure 13-2. 1. Filter Housing Cap 3. Filter Element 2. O-ring Figure 13-2 Main Fuel Filter 3. Using a 36-mm socket wrench insert, unscrew the cap on the fuel filter and remove it, along with the filter element. Pull both the cap and the filter element a short distance out of the filter housing. Allow the fuel to drain off the filter into the housing. 4. Remove the cap with the filter element. To release the filter element, twist the lower edge of the filter element to one side. NOTICE: To prevent damage to the filter housing, do not allow dirt to get into the filter housing. 5. Clean the filter housing cap. 6.

Replace the O-ring. 7. Install the new filter element in the cap. Make sure the filter element is securely in place. 8. Screw on the cap with the filter element. Tighten the cap 25 N·m (18 lb·ft). 9. Bleed the fuel system. [a] Make sure that all high-pressure lines have been tightened to 25 N·m (18 lb·ft) and all banjo bolts to 50 N·m (37 lb·ft). All information subject to change without notice. 13-12 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION