Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

13.1 SCHEDULED INTERVALS [a] Place a receptacle underneath the coolant drain plug. Choose one that is large enough to hold the expected quantity of coolant. NOTE: Make sure the coolant can flow unobstructed into the receptacle. [b] Open the coolant drain plug on the bottom of the radiator. NOTICE: When flushing the radiator, do not apply more than 20 psi (140 kPa) air pressure. Excessive pressure can damage the radiator or heater core. 4. Flush the radiator. [a] Attach a flushing gun nozzle to the radiator outlet. [b] Run water in until the radiator is full. [c] Apply no more than 20 psi (140 kPa) air pressure intermittently to help dislodge sediment buildup in the core. 5.

Drain the radiator, and flush the radiator until clean water flows from the radiator. Remove the flushing gun. 6. When the coolant has drained, install the coolant drain plug on the radiator. 7. Add coolant in the specified concentration until the maximum mark on the surge tank is reached. The coolant system capacity is listed in Table 13-10. All information subject to change without notice. 13-24 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION