1.2 CYLINDER HEAD NOTICE: Do not move the thrust bolt, because there is danger of causing a change in the position of the transfer tube. If the position of the transfer tube is changed, engine damage could result. 6. Using two wrenches, loosen the high-pressure injector line fittings. See Figure 1-4. 1. Pump-End Fitting 3. Transfer-Tube Fitting 2. High-Pressure Injector Line 4. Thrust Bolt Figure 1-4 High-Pressure Line Fittings [a] Using a paint pen, mark the location of the thrust bolt. [b] Place one wrench on the thrust bolt to secure the transfer tube. Place the other wrench on the high-pressure line fitting.
[c] Turn the wrench on the high-pressure line fitting while holding the other wrench on the thrust bolt. 7. Remove the high-pressure injector line from the head and unit pump. 8. To prevent any dirt from entering, cover the openings in the unit pump and the transfer tube. All information subject to change without notice. 1-8 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION