Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.3 CYLINDER BLOCK Measurement 1. Set the dial gauge and quick calipers with a dial caliper to the inside diameter of the cylinder liner. Preload the dial gauge to 5 mm (0.20 inch). See Figure 1-23 for set-up and listed in Table 1-10 are specifications. 1. Dial Gauge 3. Dial Caliper 2. Quick Calipers (for internal measurements) Figure 1-23 Setting the Dial Gauge Table 1-10 Cylinder Liner Measurements NOTE: This measurement serves as a baseline against which to measure the actual wear. All information subject to change without notice. 1-34 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Where To Measure What To Measure Value: mm (in.) Measuring Point 1:

At the area of the O-rings Inside Diameter of the Cylinder Liner, A Class 127.990–127.995 (5.0390–5.0392) Measuring Point 1: At the area of the O-rings Inside Diameter of the Cylinder Liner, B Class 127.995–128.005 (5.0392–5.0396) Measuring Point 1: At the area of the O-rings Inside Diameter of the Cylinder Liner, C Class 128.005–128.010 (5.0396–5.0398) Measuring Point 2: Upper Reversal Point of the First Piston Ring Max. Wear to Cylinder Liner, Measured Along Axis A and Axis B 0.08 (0.003) At Measuring Point 2, Compare Axis A to Axis B Admissible Wear Out Max.: 0.08 (0.003)