Komatsu — METHOD OF OPERATION

EXPLANATION OF COMPONENTS OPERATION SETTING CORRECT TIME 1. Press display selector button (4) to display the time. After 5 seconds, the display will return to the frequency display and the time cannot be corrected. If this happens, press display selector button (4) again. 2. Press time correction button (8) and adjust the hour and minute. H button: Adjusts hour (advances one hour each time it is pressed) M button: Adjusts minute (advances one minute each time it is pressed) If the H or M button are kept pressed, the time will advance continuously until the button is released. SET button: Every time SET button is depressed, hour and minute are reset in the following manner.

If the minute display is between 0 and 05, the minute reading will return to 00. If the minute display is between 55 and 59, the minute display will return to 00 and the hour will advance by 1. If the minute display is between 06 and 54, no resetting can be made. Example 10:05 10:00 10:59 11:00 10:26 10:26 Press the H, M, and SET buttons to set to the correct time. ANTENNA NOTICE Before transporting the machine or putting it inside a building, stored the antenna to prevent any interference. PRECAUTIONS WHEN USING To ensure safety, always keep the sound to a level where it is possible to hear outside sounds during opera- tion.

If water gets into the speaker case or radio, it may lead to an unexpected failure, so be careful not to get water on the equipment. Do not wipe the scales or buttons with benzene, thinner, or any other solvent. Wipe with a soft dry cloth. Use a cloth soaked in alcohol if the equipment is extremely dirty. When the battery is replaced, the settings for the preset buttons are all cleared, so set them again. 3-52