Komatsu — CHECKS BEFORE STARTING

OPERATION MACHINE OPERATIONS AND CONTROLS CHECKS BEFORE STARTING Always carry out the items of the checks in this section before starting the engine. CHECK COOLANT LEVEL, ADD WATER WARNING Do not open the radiator cap unless necessary. When checking the coolant, always wait for the engine to cool down and check the sub tank. Immediately after the engine is stopped, the coolant is at a high temperature and the radiator is under high internal pressure. If the cap is removed to drain the coolant in this condition, there is a hazard of burns. Wait for the tem- perature to go down, then turn the cap slowly to release the pressure before removing it. 1.

Open the door at the rear left of the machine, and check if the cooling water in sub-tank (1) (shown in the diagram on the right) is between the FULL and LOW marks. If the water level is low, add water to the FULL level through the filler port of sub-tank (1). 2. After adding water, tighten the caps securely. 3. If the sub tank is empty, there is probably leakage of water. After inspecting, repair any abnormality immediately. If there is no abnormality, check the water level in the radia- tor. If the water level is low, add water to the radiator, then fill the reserve tank (1). 3-59