Komatsu — INVERSION

OPERATION MACHINE OPERATIONS AND CONTROLS INVERSION REMARK When removing the pins, place the bucket so that it is in light contact with the ground. If the bucket is lowered strongly to the ground, the resistance will be increased and it will be difficult to remove the pins. 1. Place the bucket in contact with a flat surface. NOTICE After removing the pins, make sure that they do not become contaminated with sand or mud and that the seals of bushing on both sides do not become damaged. 2. Remove the double nut from the stopper bolt of each pin of the arm and link, remove the bolts, then take out arm pin (A) and link pin (B), and remove the bucket. 3. Reverse the bucket.

After reversing the bucket, align the mounting pin hole with the arm and link, align the arm with the link mounting hole, then align the link with the arm mounting hole and install the bucket. 4. Align the arm with holes (1) and the link with holes (2), then coat with grease and install pins (A) and (B). REMARK When reversing, do not install an O-ring. Keep the O-ring in a safe place until using it next. 5. Install the stopper bolts and nuts for each pin, then grease the pin. 3-101