Komatsu — ENGINE

TROUBLESHOOTING OPERATION ENGINE ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs.

3-130 Problem Main causes Remedy Engine oil pressure monitor lights up ● Engine oil pan oil level is low (sucking in air) ● Clogged oil filter cartridge ● Defective tightening of oil pipe, pipe joint, oil leakage from dam- aged point ● Defective engine oil pressure sensor ● Defective monitor ● Add oil to specified level, see CHECK BEFORE STARTING ● Replace cartridge, see EVERY 500 HOURS SERVICE ( ● Check, repair) ( ● Replace sensor) ( ●Replace) Steam spurts out from top of radia- tor (pressure valve) ● Cooling water level low, leakage of water ● Loose fan belt ● Dirt or scale accumulated in cooling system ● Clogged radiator fins or dam- aged fins ● Defective thermostat ● Loose radiator filler cap (high- altitude operations) ● Defective water level sensor ● Defective monitor ● Check, add water, repair, see CHECK BEFORE STARTING ● Check fan belt tension, adjust, replace ● Change coolant, flush inside of cooling system, see WHEN REQUIRED ● Clean or repair, see EVERY 500 HOURS SERVICE ( ● Replace thermostat) ● Tighten cap or replace packing ( ● Replace sensor) ( ● Replace sensor) Radiator water level monitor lights up Engine does not start when starting motor is turned ● Lack of fuel ● Air in fuel system ● Defective fuel injection pump or defective nozzle ● Starting motor cranks engine sluggishly ● Preheating monitor does not light up ● Defective compression ❍ Defective valve clearance ● Add fuel, see CHECK BEFORE STARTING ● Repair place where air is sucked in, see EVERY 500 HOURS SERVICE ( ● Replace pump or nozzle) ● See ELECTRICAL SYSTEM ● See ELECTRICAL SYSTEM ( ●Adjust valve clearance) Exhaust gas is white or blue ● Too much oil in oil pan ● Improper fuel ● Set oil to specified level, see CHECK BEFORE STARTING ● Change to specified fuel