Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

MAINTENANCE PROCEDURE MAINTENANCE Air Cleaner Element - Install NOTICE Do not use any damaged gasket or seal or element with damaged pleats. Cleaning the element or O-ring after one year has passed and using them again will cause problems. Always replace them with new parts. The seal portion on imitation parts lacks precision, and allows the entry of dust, which leads to dam- age of the engine. Do not use such imitation parts. Do not run the engine with the inner element removed. It will cause damage to the engine. 1. Check that there is no dirt or oil stuck to the seal portion of the new element or cleaned element. Wipe off any dirt or oil. 2.

When the outer element has been removed, check that the inner element has not come out of position and is not at an angle. If is is at an angle, insert your hand and push it in straight. 3. Push the outer element in straight with your hand when installing it to the air cleaner body. If the element is held and rocked lightly up and down and to the left and right while pushing it in, the element can be inserted easily. NOTICE When inserting the element, if the rubber at the tip is swollen or the outer element is not pushed in straight, and cover (3) is assembled by force to hook (2), there is danger that the hook and air cleaner body may be damaged, so be careful when assembling. 4.

Install cover (3) as follows. 1) Align cover (3) with the element. 2) Hook the tip of hook (2) to the protruding part of the air cleaner body and lock it in position. 3) When locking hooks (2) in position, apply the hooks in turn on opposite sides (top, bottom, left, right) in the same way as when tightening bolts. 4) Always install cover (3) so that the evacuator is fac- ing the ground. 5) When cover (3) is installed, check that the clearance between the air cleaner body and cover (3) is not too large. If it is too large, install again. 4-24