MAINTENANCE PROCEDURE MAINTENANCE REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) Replace the teeth before the wear reaches the adapter. WARNING It is dangerous if the work equipment moves by mis- take when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. If the locking pin is knocked out with excessive force, there is a hazard that the pin may fly out. Check that there is no one in the surrounding area. Pieces will often fly during the replacement operation, so always wear safety glasses, gloves, and other pro- tective equipment. 1.
Set the bottom of the bucket on a block to make it possi- ble to remove pin (1), check that the work equipment is stable, then set the safety lock lever to the LOCK posi- tion. Set so that the bottom of the bucket is horizontal. 2. Place a bar on the pin head and strike the bar with a hammer to knock out pin (1). Remove tooth (2). REMARK Use a round bar with a smaller diameter than that of the pin. 3. Clean the mounting face. Fit a new tooth (2) in the adapter, push in pin (1) partially by hand, then lock it with a hammer to install the tooth to the bucket. 4-36