Komatsu — LUBRICATING

MAINTENANCE MAINTENANCE PROCEDURE EVERY 100 HOURS MAINTENANCE LUBRICATING NOTICE If any abnormal noise is generated at the greasing point, carry out greasing regardless of the mainte- nance interval. When operating the machine for the first 50 hours, carry out the greasing every 10 hours. After carrying out digging work in water, always greasing the pins that were under water. 1. Set the work equipment in the greasing posture below, then lower the work equipment to the ground and stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. 4-47