Komatsu — CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL

MAINTENANCE PROCEDURE MAINTENANCE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare a hexagonal wrench. 1. Set the final drive so that TOP mark comes to the top and the mark and plug (P) are perpendicular to the ground. 2. Using a hexagonal wrench, remove plug (F) and check that the oil level is within a range from the bottom of the plug hole to a point 10 mm(0.4 in) below it. 3.

If the oil level is too low, install plug (F), operate the travel levers, and drive forward or in reverse to rotate the sprocket one turn. Then repeat Step 2 to check again. 4. If the oil level is still too low, add engine oil through the hole in plug (F) until the oil overflows. 5. After checking, install plug (F). REMARK There are two plugs (F). Add oil through the one easier to fill oil and through which no internal gears are to be seen. 4-50