MAINTENANCE PROCEDURE MAINTENANCE EVERY 1000 HOURS MAINTENANCE Maintenance for every 100, 250 and 500 hours service should be carried out at the same time. REPLACE HYDRAULIC FILTER ELEMENT WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the hydraulic tank strainer. When the oil filler cap is removed, oil may spurt out, so turn the cap slowly to release the internal pressure,then remove it carefully. NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than dur- ing normal bucket operations.
For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-19)" when carrying out maintenance. 1. Set the work equipment on the hard and flat ground in the maintenance posture as shown in the figure, then lower it to the ground and stop the engine. 2. Remove the cap from oil filler (F), and release the internal pressure. 3. Loosen 6 bolts, then remove cover (1). When doing this, the cover may fly out under the force of spring (2), so hold the cover down when removing the bolts. 4. After removing spring (2), valve (3) and strainer (4), take out element (5). Inspect the bottom of the filter case for dirt, and remove it, if any.
Take good care then not to let fall the dirt into the hydraulic tank. 5. Clean the removed parts in diesel oil. 6. Install the new element in the place where old element (4) was installed. 7. Set valve (3), strainer (4) and spring (2) on top of the ele- ment. 8. Set cover (1) in position, push it down by hand, and install the cover with the mounting bolts. 9. Install the oil filler cap. 4-62