ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE HANDLING CLAMSHELL BUCKET This bucket is used for digging and loading in side-ditches or the confined spaces. How to perform excavation This clamshell digs by pushing the boom against the ground. However, when perform bucket operation, perform digging while gradually raising the boom. If the clamshell bucket rotates, relieve the bucket cylinder pressure then set the lever to the neutral position. This can temporarily stop the rotation. PRECAUTIONS WHEN USING For safety, always avoid abrupt traveling, swing and stopping. Make the teeth of the bucket vertical in digging. Do not swing the bucket to crush the rock or to cut through soil.
Do not use the bucket for hammering or pulling out piles etc. Before leaving the machine, open the bucket and lower it to the ground. REMARK Remove the bucket from the arm when transporting the machine. LUBRICATING Prepare a grease pump. 1. Stop the machine on firm horizontal ground, lower the work equipment to the ground, then stop the engine. 2. Using a grease pump, pump in grease through grease fit- tings (12 points) shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. 6-29