OPERATION EXPLANATION OF COMPONENTS SWITCHES (1) Starting switch (8) Knob switch (2) Fuel control dial (9) Room lamp switch (3) Cigarette lighter (10) Emergency pump drive switch (4) Swing lock switch (11) Swing brake cancel switch (5) Lamp switch (12) Rotating lamp switch (6) Alarm buzzer stop switch (7) Horn switch STARTING SWITCH This switch (1) is used to start or stop the engine. OFF position The key can be inserted or withdrawn. The switches for the electric system except the room lamp, are all turned off and the engine is stopped. ON position Electric current flows in the charging and lamp circuits. Keep the starting switch key at the ON position while the engine is running.
START position This is the engine-start position. Keep the key at this position during cranking. Immediately after starting the engine, release the key. It will automatically return to the ON position. HEAT (preheat) position When starting the engine in winter, set the key to this position. Whenthe key is set to the HEAT position, the pre- heating monitor lightsup. Keep the key at this position until the monitor lamp flashes.Immediately after the pre- heating monitor flashes, release the key.The key automatically returns to the OFF position. Then, start the engine by turning the key to the START position. 3-17