Freightliner — Century Class Maintenance Manual

Front Axle 33 33–00 Safety Precautions Safety Precautions in this section apply to all procedures within this group. 1 DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. A 33–01 Knuckle Pin Lubrication, Meritor Axles 09/06/96 f320032a 1 A. Grease Exit 1. Grease Fitting Fig. 1, Meritor Knuckle Pin Lubrication Use regulated pressure when lubricating the knuckle assemblies, otherwise damage could re- sult to the knuckle caps.

structions, see Group 33 of the Century Class Trucks Workshop Manual . When lubricating knuckle pin bushings, do not raise the front axle. Wipe the lube fittings clean, and apply multipurpose chassis grease, NLGI Grade 1 (6% 12- hydroxy lithium stearate grease) or NLGI Grade 2 (8% 12-hydroxy lithium stearate grease) until new grease is seen at the bushing grease seal opposite the fittings. The grease seal will accept grease pres- sure without damage, and is designed to have grease pumped out through it during lubrication. Even if grease leaks out around the top, or bottom- plate gasket, continue pumping until new grease is seen at the bushing seal opposite the grease fitting. See Fig. 1 .

OK 1 OK 33–02 Tie Rod Inspection Inspect the tie-rod ends as follows: 1. Shake the cross-tube. A loose fit, or movement between the tapered shaft of the ball and the cross-tube socket members indicates that the tie-rod end assembly must be replaced. 02/27/2007 NOTE: Shown without pinch bolt to provide clarity. f320033a 2. The threaded portion of the tie-rod end assembly must be inserted all the way into the cross-tube split for adequate clamping. See Fig. 2 . Replace the components if this cannot be done. For in- 1. Cross-Tube Split Fig. 2, Tie-Rod End Adjustment Century Class Trucks Maintenance Manual, August 2017 33/1 CAUTION