Front Axle 33 f330298 09/01/2016 f330300 09/01/2016 Fig. 10, Normal Oil Venting Fig. 12, Water in Oil clean before checking the oil. Do not use a pres- sure washer to clean the hub/plug area. The plug has a vent and this can contaminate the oil with water. 1. Park the vehicle on a level surface, shut down the engine and set the parking brakes. Chock the tires. 2. Inspect the axle hub cap and vent plug for evi- dence of excessive leakage. 3. Wipe the hub cap and vent plug clean with a rag. 4. Remove the vent plug and check the oil for evi- dence of water contamination.
If there is evidence of water contaminated oil in the hub, disassemble the effected axle end, clean, inspect, and reassemble the axle end. For instructions, refer to Group 33 of the vehicle’s Workshop Manual. f330299 09/01/2016 If there is evidence of excessive leakage, re- move the damaged part and replace it with a new part. Fig. 11, Excessive Leakage Inspection 5. Check the oil level in the hub, and fill the hub with new approved oil as needed. NOTICE Only remove vent plugs by hand. They can be damaged if a tool is used. Wipe the hub/plug area Century Class Trucks Maintenance Manual, August 2017 33/7