Rear Axle 35 2. If the vehicle has just been driven, allow a few minutes for the lubricant to settle. 3. Clean the oil fill plug and area surrounding it, then remove the plug from the fill hole (see Fig. 3 ), or from the standpipe (if so equipped) installed in the fill hole. 1 IMPORTANT: A lubricant level close enough to be seen or touched is not sufficient. It must be level with the bottom of the fill hole (see Fig. 2 ), or the top of the standpipe opening. 2 3 4. Lubricant should be level with the bottom of the fill hole (see Fig. 2 ), or with the top of the stand- pipe opening. If low, check the axle for oil leaks, and correct as needed. Add lubricant as re- quired.
See Table 3 for recommended drive axle lubricants. f350002a 10/06/2016 1. Axle Housing Breather 2. Fill Plug 3. Temperature Indicator Plug IMPORTANT: Axle housing breathers (see Fig. 8 ) must remain clean and unclogged. Al- ways check the axle breather whenever check- ing lubricant level. Ensure that it is open and unclogged. Check the breather more frequently under adverse operating conditions. If the breather is plugged or damaged, clean or re- place it as needed. Fig. 8, Dana Spicer Axle Housing Breather oil fill hole. This smaller hole is for a lubricant temperature indicator only, and should not be used as a fill or level hole. 3.
Check that the lubricant is level with the bottom of the fill hole. See Fig. 2 . If low, check for oil leaks, and correct as needed. Add the specified lubricant. See Table 5 for recommended drive axle lubricants. 5. Install and tighten the fill plug 40 to 60 lbf·ft (54 to 81 N·m). 6. For a two-speed axle with a shift unit, check the lubricant level of the shift unit; see elsewhere in this maintenance operation for the shift unit lubri- cant level inspection procedure. 4. Install and tighten the fill plug 35 lbf·ft (47 N·m). IMPORTANT: Axle housing breathers (see Fig. 9 ) must remain clean and unclogged. Al- ways check the axle breather whenever check- ing lubricant level.
Ensure that it is open and unclogged. Check the breather more frequently under adverse operating conditions. If the breather is plugged or damaged, clean or re- place it as needed. 7. Remove the chocks from the tires. Meritor Axle NOTICE 5. For a two-speed axle with a shift unit, check the lubricant level of the shift unit; see elsewhere in this maintenance operation for the shift unit lubri- cant level inspection procedure. Failure to keep the rear axle filled to the proper level with the recommended lubricant can result in rear axle damage. 1. Park the vehicle on level ground, apply the park- ing brakes, and chock the tires. 6.
On non-drive axles using oil-lubricated wheel bearings, check oil level at the wheels, and add oil if low. Use the same lubricant as specified for the drive axle. NOTE: When adding to or checking the oil level, make certain the hub cap and plug are clean before removing the plug; this will minimize the 2. Clean the fill plug and the area surrounding the fill plug on the side of the axle carrier. See Fig. 3 . Remove the plug. NOTE: Some Meritor axles have a small tapped and plugged hole near and below the housing Century Class Trucks Maintenance Manual, January 2016 35/8