Brakes 42 42–00 Safety Precautions 4. Disconnect the harness connector from the heater and thermostat assembly. Safety Precautions in this section apply to all procedures within this group. 5. Loosen the capscrew securing the upper mount- ing bracket strap. DANGER 6. Remove the two capscrews that secure the air dryer to the lower mounting bracket. Mark the position of the mounting bracket to the end cover, and mark the capscrews to ease installa- tion. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop.
Failure to follow these steps could result in serious personal injury or death. 7. Remove the upper mounting bracket strap cap- screw, and remove the air dryer from the vehicle. 8. Place the air dryer on a bench and remove the remaining 6 capscrews, 12 washers, 6 Nylok®nuts, and the air dryer housing. See Fig. 1 . Discard the Nylok nuts. Remove the end- cover-to-housing O-ring. 42–01 Air Brake System Valve Inspection 9. Clamp the desiccant cartridge in a vise. NOTE: There is no scheduled air valve mainte- nance on vehicles equipped with Bendix air valves and a Bendix air dryer if the air dryer desiccant is replaced at 350,000 miles (563 000 km).
If the desiccant is not changed at 350,000 miles (563 000 km), or if the vehicle is equipped with another air dryer, maintenance will have to be performed to the air brake valves. See Group 42 of the Century Class Trucks Work- shop Manual for procedures. Clamping the end cover or housing in a vise could seriously compromise the air dryer’s ability to hold air pressure, which could cause a failure in the brake system. 10. Twist the end cover counterclockwise to release the cartridge from the end cover. Rotate the end cover until it completely separates from the des- iccant cartridge. NOTE: A substantial torque, up to 50 lbf·ft (68 N·m), may be necessary to remove the desic- cant cartridge.
42–02 Air Dryer Desiccant Replacement 11. Inspect the condition of the O-ring seals. If they are cracked, crimped, or otherwise damaged, replace them to ensure an airtight seal. Clean the O-ring grooves of any dirt or obstruction. Bendix AD-9 Air Dryers 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. 2. Completely drain all air reservoirs. Air pressure gauges should read 0 psi (0 kPa). Dirt or obstructions in the O-ring grooves can cause an O-ring failure that will result in an air leak. The compressor discharge line may still contain residual air pressure. 12.
Lubricate the O-rings with silicone or lithium grease and install them in the end cover. 13. Install the desiccant cartridge on the end cover. Turn the cartridge clockwise until the desiccant cartridge makes contact with the end cover. 3. Identify, tag, and disconnect the three air lines from the end cover. Century Class Trucks Maintenance Manual, January 2016 42/1 CAUTION CAUTION CAUTION