Freightliner — Century Class Maintenance Manual

Fuel 47 47–00 Safety Precautions 5. Lightly lubricate the threads on the sight bowl with oil, then thread the sight bowl into the bot- tom of the fuel separator. Safety Precautions in this section apply to all procedures within this group. 6. Hand-tighten until the gasket is in full contact with the fuel separator, then tighten an additional 1/4 to 1/3 turn. DANGER When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. 7.

Check that the drain valve is tightened and closed. 8. Prime the fuel separator. 8.1 Remove the vacuum breaker fitting and fill the unit with diesel fuel. 8.2 Replace and close the vacuum breaker fitting when the unit is full of fuel. 47–01 Fuel Filter Replacement IMPORTANT: The fitting must be air-tight and the valve closed. Refer to the engine manufacturer’s service manual for removal and installation procedures. Racor Fuel Separator Element Replacement 47–02 Fuel Separator Sight Bowl Cleaning and Element Replacement The only service necessary on Racor fuel separators is to replace the filter element.

Racor 490 ConMet Fuel Separator Sight Bowl Cleaning WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source. Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. The only maintenance necessary on ConMet fuel separators is to clean the sight bowl, if equipped. See Fig. 1 . WARNING Diesel fuel is flammable and can ignite if exposed to an open flame, intense heat, or other ignition source.

Do not drain fuel near, or expose fuel vapor to open flame or intense heat. Exposure to open flame or intense heat could start a fire, pos- sibly resulting in personal injury or property dam- age. When working on a fuel system, have a fire extinguisher within easy reach. 1. Drain off some fuel by loosening the vent plug and opening the drain valve. 2. Disconnect the water sensor and heater connec- tions, if equipped. 3. Remove the element and bowl, together, by turn- ing counterclockwise. 1. Drain the fuel separator. 2. Unscrew the sight bowl from the fuel separator. 4. Remove the bowl from the element, and clean the O-ring. 3. Wipe the sight bowl clean using a soft cloth. 5.

Apply a coating of clean fuel or motor oil to the new O-ring and element seal. 4. Lubricate the gasket with a film of oil, and rein- stall it on the sight bowl. If the gasket appears dry-rotted or damaged, replace the gasket. Century Class Trucks Maintenance Manual, January 2016 47/1