Exhaust 49 maintenance inspections. If any discrepancies are discovered, refer to the engine manufactur- er’s service literature for repair instructions. Inspection 1. Check for leakage at the clamp that attaches the 6 5 7 1 2 2 5 3 4 8 9 3 10/20/2006 A f490283 A. Inspect this area of the canister for dents. 1. Marmon Fitting at Inlet from Turbocharger 2. DOC Temperature Sensor 3. ATD Mounting Band 4. DPF Intake Pressure Sensor 5. DPF V-Band Mounting Clamps 6. Sensor Housing 7. DPF Outlet Temperature Sensor 8. Exhaust Outlet Marmon Fitting 9. DPF Outlet Pressure Sensor Fig. 7, Typical After-Treatment Device Definitions of ATS Components exhaust pipe to the turbocharger exhaust outlet.
If leakage exists, tighten the nut on the clamp to the required torque. If leakage persists, install a new clamp. Refer to the following list of definitions of ATS com- ponents. After-Treatment System (ATS)—the entire ex- haust system from the turbocharger to the ex- haust stack or tail pipe. 2. Check the exhaust pipe, bellows, and each ex- haust seal clamp for leakage, wear, cracks, or damage. Replace damaged components as needed. If leakage exists at a clamp, tighten the nuts to the required torque. If leakage persists, install a new exhaust seal clamp. Do not reuse seal clamps. Once a seal clamp is loosened or removed, it must be replaced.
After-Treatment Device (ATD)—a muffler-like canister that houses a DPF, DOC, and sensors. Diesel Particulate Filter (DPF)—a filter that col- lects and holds particulate matter (soot and ash). Diesel Oxidation Catalyst (DOC)—oxidizes hy- drocarbons and reduces NOx. NOTICE Sensors—detect temperatures and pressures in the ATS. A leak in the CGI piping, including the bellows, will allow unfiltered air and contaminants into the engine intake, and can cause serious engine dam- age. Century Class Trucks Maintenance Manual, January 2016 49/3