Freightliner — Century Class Maintenance Manual

Frame and Frame Components 31 31–00 Safety Precautions 6. Check the jaw and stationary jaw for mushroom- ing, and check that the serrations at the jaw and wedge are in good condition. Safety Precautions in this section apply to all procedures within this group. 7. Test the secondary safety lock latch for ease of operation. DANGER 8. Check for loose nuts or bolts on the fifth wheel and the mounting. Set a torque wrench to the maximum torque value for the bolt being checked, and confirm that the torque is to speci- fication. Do not loosen the bolt to check the torque. See Group 00 for bolt torque specifica- tions.

When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle cannot drop. Failure to follow these steps could result in serious personal injury or death. 9. Check all springs to see if they are securely fas- tened, and are not deformed. 31–01 Fifth Wheel Inspection WARNING WARNING Do not disassemble the fifth wheel to inspect the springs. The springs are under extreme pressure, and could cause serious injury. All fifth wheel maintenance, adjustment, and re- building must be done only by a qualified me- chanic.

Improper or incomplete procedures could result in a possible disengagement of the trailer from the tractor, which could result in personal injury or property damage. 10. Check the wedge adjustment. 10.1 Close the fifth wheel on a standard 2-inch (50-mm) kingpin or similar 2-inch (50-mm) diameter shaft so that it locks. Parts are under spring compression. Wear safety goggles while servicing the fifth wheel. Failure to do so can result in personal injury, due to parts ejecting with force. Fontaine 10.2 Push on the wedge stop rod with hand pressure. It should move in 1/4 inch (6 mm) and spring back out on release.

If the free travel is not 1/4 inch (6 mm), adjust the distance to 1/4 inch (6 mm) by turning the wedge stop rod, on the right side of the top plate, clockwise to reduce the gap and counter-clockwise to in- crease it. 1. Disconnect the tractor from the trailer. For in- structions, see the Century Class Driver’s Manual . 2. Thoroughly steam clean the fifth wheel. 11. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 SAE grade 8 bolts, grade C locknuts, and hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. 3. Check for cracks in the fifth wheel assembly, mounting brackets, and mounting parts. 4.

Ensure that both bracket pins are in place and secured by retainer pins and cotter pins. See Fig. 1 . 12. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. Apply a generous coating of grease to the top plate to fill the grooves, or depressions, on the top plate. See MOP 31–02 for lubrication instruc- tions. 5. For fifth wheels equipped with bracket liners, rock the fifth wheel. If it does not rock freely, re- move the top plate and inspect the bracket lin- ers. Replace liners that are broken or less than 0.125 inch (3 mm) thick at the top of the liners. For the liner replacement procedure, see the Fontaine website, www.fifthwheel.com .

Century Class Trucks Maintenance Manual, January 2016 31/1