. MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 39 If the engine is run at hig h speed immediately after startup or a cylinder i s pushed up to its stroke en d, air taken inside the c ylinder may cause damage to th 4. Bleeding air from swing motor (bleed the air only when the oil inside the swing motor case has been drained) When oil has been drained from inside swing motor case 1) Run the engine at low idling, loosen hose (1), and check that oil oozes out from hose (1). NOTICE Do not operate the swing under any circumstances. 2) If oil does not ooze out, stop the engine, remove hose (1), and fill the inside of the motor case with hydraulic oil. 4.
Bleeding air from swing motor (bleed the air only when the oil inside the swing mot or case has been drained) een drained from inside swing m otor case e at low idling, loosen Do not operate the swin g under any circumstance ooze out, stop the engine, remo ve hose ( ide of the motor case w ith hydra ely bleeding the air, tighten hose (1). e at low idle, and slowly swing th e upper str uctur e at least 2 times u niformly to the left and right. NOTICE om the swing motor, the motor bearings may be damaged. If the air is not bled fr om the swing motor, the motor bea rings may b Use the above proced ure also to bleed the air w hen the s wing moto r safet y valve has been rep 5.
Bleeding air from attachment (when installed) If an attachment h (approx. 10 times as been installed, run the engin e at low i dling and operate the at tachment pedal repeatedly ) until the air has been bled from the attachmen t and circuit. NOTICE If the method of blee ding the air from the attachment its elf is specified b y the manufacturer, bleed the air according to the specified procedure. After completing the air bleeding operation, sto p the engi ne, and lea ve the machine for 5 minut es before starting operations. This will remove the a ir bubbles in the oil insid e the hydr aulic cylinders. Check that there is no leakage of oil and wipe o ff any oil that has be