Service and Maintenance 6.5 Belt Drives © 24 598 1 In order to retension, remove one or more inner washers 3. Place the removed wash- ers on the outside on the removed belt pulley half 2. Tighten screw 1 again. Whilst tightening, turn engine over simultaneously in order to prevent crushing the V-belt. After installing new belts, run engine for 15 minutes, then check belt tension. 6.5.6 Tensioning or changing V-belts Unscrew hex screw 1. Remove outer belt pulley half 2. Replace V-belt if necessary. © 2001 6 © 24 598 1 © 24 598 1 © 24 599 1 © 24 599 1