GENERAL FUEL COOLANT AND LUBRICANTS 12 FUEL COOLANT AND LUBRICANTS It is not our policy to approve fuel, coolant and lubricants or to guarantee performance in service. The responsibility for the quality of the fuel, coolant and lubricant must remain with the supplier. When in doubt, consult your distributor. The specified fuel, coolant and lubricants recommended for this machine are as shown in the following table. API: American Petroleum Institute NLGI: National Lubricating Grease Institute ASTM: American Society of Testing and Materials SAE: Society of Automotive Engineers Specified Capacity: Total amount of oil including oil for components and piping. Refill Capacity:
Amount of oil needed to refill system during normal maintenance. Other equipment may be necessary when operating the machine at temperatures below -20°C, therefore consult your distribu- tor for your specific needs. PC200-6LL/PC220LL-6 01-11 RESERVOIR TYPE AMBIENT TEMPERATURE CAPACITY (L) °C -30 -20 -10 0 10 20 30 40 50 Specified Refill Crankcase Engine oil See page 01-11.
26.3 24.0 SAE 30 SAE 10W SAE 10W-30 SAE 15W-40 Damper case 0.75 - - Swing case SAE 30 5.5 5.5 Final drive (each) 4.4 4.2 Front idler (each) 0.07 TO 0.08 0.07 TO 0.08 Track roller (each) SAE 30 0.19 TO 0.21 0.19 TO 0.21 Top idler (each) 0.23 TO 0.25 0.23 TO 02.5 PC200 239 PC220 246 166 SAE 10W Hydraulic system SAE 10W-30 SAE 15W-40 Fuel tank DF 340 - - D975 No. 2 D975 No. 1 All lube fittings Grease FILL AS INSTRUCTED Komatsu Super Grease or NLGI No.2 lithium MPG with 3% molybdenum disulfide Cooling system See COOLANT SPECIFICATIONS on page 01-12. PC200 22.2 PC220 23.2 - -