Komatsu — FINAL DRIVE OIL SPECIFICATIONS

GENERAL FUEL COOLANT AND LUBRICANTS NOTICE: Classification CD, CE, CD/SF or CE/SF oils may be used in areas where CF-4, CG-4, CF-4/SG or CG-4/SH oil is not yet available. NOTICE: The track front idlers, track rollers and top carrier rollers are lubricated for the life of the component. Lubrication should only be necessary during rebuild. FINAL DRIVE OIL SPECIFICATIONS Komatsu Engine Oil or engine oil meeting American Petroleum Institute (API) performance classification CF-4, CG-4, CF-4/ SG or CG-4/SH or MIL-L-2104D or E is recommended. NOTICE: Classification CD, CE, CD/SF or CE/SF oils may be used in areas where CF-4, CG-4, CF-4/SG or CG-4/SH oil is not yet available.

DIESEL FUEL SPECIFICATIONS WARNING! Possible fire hazard - never mix gasoline, gasohol and/or alcohol with diesel fuel. This practice creates an extreme fire hazard and under certain conditions an explo- sion which could result in personal injury or death. WARNING! Never remove the fuel tank filler cap or refill the fuel tank while the engine is run- ning or when hot or when the machine is indoors. Fumes are dangerous, a spark or flame could result in a fire or explosion. NOTICE: Due to the precise tolerances of diesel fuel injection systems, it is extremely important that the fuel be kept clean and free of contaminates or water.

Contaminates or water in the system can cause severe damage to both the injection pump and nozzles. REMARK Below -12°C the paraffin in ASTM Grade No. 2-D diesel fuel will change to wax particles and clog the fuel filters. For best results use Grade No. 1-D diesel fuel in cold weather. For normal service above -10°C, the use of ASTM Grade No. 2-D diesel fuel with a minimum Cetane number of 40 is recom- mended. The use of No. 2-D diesel fuel will result in optimum engine performance under most operating conditions. Fuels with Cetane numbers higher than 40 may be needed in high altitudes or extremely low ambient temperatures to prevent mis- fires and excessive smoke.

At operating temperatures below -10°C or extended engine idling, use ASTM Grade No. 1-D diesel fuel. The use of lighter fuels can reduce fuel economy. Where a winterized blend of Grade No. 2-D and No. 1-D fuels is available, it may be substituted for Grade No. 1-D fuel. How- ever, it is the supplier's responsibility to provide the fuel for the anticipated ambient temperature. Use a low sulfur content fuel having a cloud point that is at least 10 degrees below the lowest expected fuel temperature. Cloud point is the temperature at which crystals begin to form in the fuel. The viscosity of the fuel must be kept above 1.3 cSt to provide adequate fuel system lubrication.

Optionally, the equivalent grades of recognized Federal Government specifications may be used; the latest revisions of VV-F- 800a. PC200-6LL/PC220LL-6 01-13