16. Slide the backing plate down into the clutch carrier. See Figure 4-196. Set the spur gear down onto the clutch carrier. The splines on the spur gear must engage the inner teeth on FIGURE 4-205 4643 FIGURE 4-207 4645 the clutch plates. Determining Shim Washer Thickness FIGURE 4-208 4646 FIGURE 4-206 4644 NOTE The following steps describe taking measurements and using the measurements to make a calculation. The measurements shown in these steps are an example only. Be sure to take your own measure- ments on the transmission you are working on, and perform your own calculation. 1. Place the split tab washer and the grooved disc over the bore in the bottom of the trans- mission.
See Figure 4-197. Lay the gasket in place on the bore on the top of the transmis- sion. Use a depth micrometer to measure from the gasket on the top bore, to the sur- face of the grooved disc in the bottom bore. In this example, this distance is 248.5 mm (9.783"). This is measurement A. 4-54 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual