daewoo — Daewoo Wheel Loader Shop Manual

Pump Installation 1. Install 2 square seal rings on the shaft FIGURE 4-281 4719 See Figure 4-279. FIGURE 4-279 4717 7. Install the snap ring on the pump drive shaft. See Figure 4-280. Heat the bearing (RS) and (WK type). See Figure 4-274. Install 1 square ring on the shaft (non WK type). Install the roll pins, 2.5 x 5 mm (.098 x .196") and 1.5 x 5 mm (.059 x .196"). 2. Install the bearing into the oil supply flange. Insert the shoulder side of the bearing first. FIGURE 4-282 4720 slide it onto the shaft until it contacts the snap ring. The bearing must be positioned so that FIGURE 4-280 4718 Apply grease to the pump shaft and insert it into the oil supply flange. See Figure 4-275. 3.

Install the bearing race into the oil supply flange. See Figure 4-276. 4. Set the spur gear into the oil supply flange. See Figure 4-277. Position the spur gear so that the longer hub of the gear will face the oil pump. 5. Slide the shaft through the spur gear and into the oil supply flange. See Figure 4-278. Be sure to engage the spline on the shaft with the spline inside the spur gear hub. FIGURE 4-283 4721 the shielded side of the bearing contacts the snap ring. Install the key into the slot on the shaft. 6. Install the ball bearing into the housing. Install the snap ring to hold the bearing in place. 8. Install the drive shaft into the pump.

See 4-70 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual