daewoo — Daewoo Wheel Loader Shop Manual

Brake System The brake hydraulic system also contains 5 accu- mulators (8, Figure 6-9). The accumulators hold a volume of pressurized fluid large enough to allow the brakes to be applied 9 times with full pressure, after the engine has been turned off. Wheel Brake Hydraulic Circuit Multiple wet disc brakes for stopping vehicle move- ment are contained in the axle-end planetary gear sets. A brake pump supplies pressurized fluid to the brake hydraulic system. Force on the brake pedal moves 2 spools in the brake valve (5, Figure 6-9). The spools are proportional. The farther the brake pedal is pushed, the greater the amount of fluid that passes through each spool.

One spool ports fluid to brake pistons in the front axle (3). The other spool ports fluid to brake pistons in the rear axle (1). Pressure on the brake pistons applies pressure to the brake discs, and this stops axle shaft and wheel rotation. The brake hydraulic system includes a pressure operated transmission cut-off switch (2). Pressing the brake pedal will open cut-off switch (2). When the transmission cut-off switch in the operator’s cab is selected, this will cut off current to a solenoid operated hydraulic valve in the transmission. This prevents operation of the forward clutch in the transmission.

This prevents the transmission from driving the wheels forward when the brake pedal is pressed. 1. Rear Axle 2. Transmission Cut-off Switch 3. Front Axle 4. Brake 5. Brake Pedal 6. Brake Pedal Switch 7. Parking Brake 8. Accumulators 9. Brake Valve 10. Pump 11. Pilot Cut-off Line 12. Safety Valve 13. Low Pressure Warning Switch 14. Parking Brake Valve FIGURE 6-9 4925 Mega 300-III Shop Manual AXLES 6-13