When the brake pedal is depressed, force is applied to the working element (6, Figure 6-11). This force is transferred to the primary control spool (3) and the secondary control spool (4) by the main control spring (5). This causes the control spool lands to close the path from the supply ports (P1 and P2) to the tank ports (T1 and T2). Simultaneously, the spools then open a path from the brake circuit ports (Br1 and Br2) to the supply ports (P1 and P2). Drilled passages in the control spools (3 and 4) allow fluid pressure in ports P1 and P2 to act against the main control spring (5).
This allows the brake pressure in both circuits to rise proportionally to the force applied to the brake pedal. As the force applied to the brake pedal becomes constant, the control spools (3 and 4) move into a balanced position and hold the braking pressure constant. When force is removed from the brake pedal, this removes force from the control spring. The return springs (7 and 8) now move the control spools (3 and 4) to the right. The spools open a path from the brake circuit ports (Br1 and Br2) to the tank ports (T1 and T2) and this releases the pressure from the brake circuits. 1. Primary Housing 2. Secondary Housing 3. Primary Control Spool 4. Secondary Control Spool 5.
Main Control Spring 6. Working Element 7. Primary Return Spring 8. Secondary Return Spring 9. Pilot Passages FIGURE 6-11 3753 Mega 300-III Shop Manual AXLES 6-15