Brake System Pressure Checks 1. Attach a gauge to the ULTP Port (2, Figure 6-13) (brake pump pressure check port) of the brake supply valve. Accumulator Check Run the engine long enough to fill the brake system accumulators. Then turn off the engine. Apply the brakes with the engine turned off. There should be enough pressure in the accumulators to apply the brakes for both the front and rear axles. If the accu- mulators do not hold enough pressure to apply the brakes, the accumulators can be removed and inspected. 2. With the gauge installed, measure pressure as soon as the engine starts. This will ensure that the pressure is measured at maximum engine RPM.
At maximum engine RPM, the pressure should rise to 140 bar until the unloading cartridge (C4) unloads pressure. Pressure should now fall to 0. Before starting to work on accumulator removal, all pressure must be exhausted from the oil side of the accumulators. Maximum accumulator oil pressure is 140 bar. 3. If no pressure is measured in Step 2, disas- semble and clean C4, the unloading valve. If C4 operates normally, check valves C6, C7, C8, and C9. WARNING!!! Brake Disc Pressure Check When the brake pedal is pressed down, maximum pressure applied to the brake discs in the axle is 60 bar. To check pressure output from the brake pedal valve, remove the pressure switch from the valve.
Install a gauge in the switch port. Operate the brake pedal and check the pressure displayed on the gauge. If oil fittings on an accumulator are loos- ened before accumulator pressure has been exhausted, hot pressurized oil could be sprayed into the eyes, face, or skin of the person working on the accumulator. Pilot Line Pressure Check The pump section that provides oil for the brake system also provides oil for the pilot valves. The pilot valves direct this oil to the bucket, boom, and option valves. The oil supply for the pilot valves passes through the brake supply valve. The brake supply valve controls the supply pressure of this oil.
To check the pressure of the oil being supplied to the pilot valves, perform the following steps. To exhaust the pressure, first turn the engine off. Then press the brake pedal at least 9 times. Or turn the parking brake switch on and off for at least 9 cycles. When all oil pressure has been exhausted, it is safe to start accumulator removal. 1. Install a pressure gauge into the TP Port (3, Figure 6-13) of the brake supply valve. 2. With the gauge installed, measure pressure as soon as the engine starts. This will ensure that the pressure is measured at maximum engine RPM. At maximum engine RPM, the pressure should be 30 bar. 3.
If pressure is low or nonexistent, disassemble and clean valves C6 and C7. Mega 300-III Shop Manual AXLES 6-17