Accumulator The illustrations on this page show the position of the diaphragm in six possible positions. See Figure 7-114. The accumulator is a gas-charged storage device designed to hold a reserve quantity of hydraulic fluid under pressure. Accumulators are used in hydraulic circuits in much the same way that condensers (or capacitors) are used to collect, store and maintain electrical charge in a circuit. 1. With no gas charge in the upper chamber (0 psi, empty) and no oil in the bottom (0 psi, dry) the elastic diaphragm hangs loosely.
In a hydraulic circuit, minor variations or lags in pump output that might otherwise cause unsteady or irregular operation are made up from the supply of pressurized oil in the accumulator. 2. When the pre-pressure charge of gas (usually nitrogen) is introduced through the valve at the top of the accumulator, the diaphragm expands to maximum size. The valve button in the center of the diaphragm pushes into the fluid opening in the bottom chamber, sealing off the lower valve. If the pressure of the gas charge exceeds system oil pressure, no fluid enters the accumulator. The button also keeps the diaphragm from protruding into the lower valve opening.
Accumulators are solidly constructed to resist the high operating pressures of the fluids they contain. There are only three main moving parts: a valve assembly at the top allows adding or expelling gas from the compressible, precharged upper chamber; a valve assembly at the bottom of the accumulator for passing hydraulic fluid in and out, and an elastic diaphragm to separate the two chambers. See Figure 7-113. The flexible diaphragm changes shape to conform to the changing pressures and volumes of the two fluids in the upper and lower chambers. 1. Without Nitrogen Fill 2. Pre-pressurized with Nitrogen to Pre-pressure P1 3. Storage of Pressure Fluid 4. Charged to Maximum Pressure P3 5.
Discharge of Pressure Fluid 6. Discharged Down to Minimum Pressure P2 DIAPHRAGM TYPE ACCUMULATOR (CROSS SECTION) 1. Screw Plug 2. Sealing Ring 3. Diaphragm 4. Fluid Valve 5. Steel Pressure Vessel 6. Valve Button FIGURE 7-114 0361 FIGURE 7-113 4032 7-40 HYDRAULIC SYSTEM Mega 300-III Shop Manual