NOTE Windshield Wiper Circuit The preheat relay has a replaceable protective When the wiper switch (1, Figure 9-5) is in the I position, current is directed out of the switch at terminal 53. This current flows to terminal 53 on the wiper motor (2) and out to ground at terminal 31b. This powers the wiper at low speed. 1. Terminal B 2. Fuse 3. Amperage Marked 4. Terminal H 5. Terminal C When the wiper switch (1) is in the II position, cur- rent is directed out of the switch at terminal 53b. This current flows to terminal 53b on the wiper motor (2) and out to ground at terminal 31b. This powers the wiper at high speed.
When the wiper switch (1) is in the J position, cur- rent is directed out of the switch at terminal J. This current flows to terminals 1, 2, and 3 of the wiper timer (3). The wiper timer sends an intermittent out- put to terminal 86 of the timer relay (4). This ener- gizes the coil in the relay, and connects terminal 30 to terminal 87 inside the relay. This allows current from the fused power line to flow from 87 to 30 through the timer relay, and into terminal 31b on the wiper switch (1). Current flows from 31b to ter- minal 53 on the switch, and out to 53 on the wiper motor (2). This powers the wiper motor in an inter- mittent cycle. FIGURE 9-4 0275 fuse. See Figure 9-4.
The cycle of current output from the wiper timer (3) can be shown on a graph. See Figure 9-6. The wiper motor (2) operates only when the current is at the high level (t1). The wiper motor is not powered during time t2. The time necessary to complete 1 cycle is 5.7 seconds. 9-8 ELECTRICAL SYSTEM Mega 300-III Shop Manual