Long Term Storage Cleaning Pressure wash the machine. Inspect the machine for any damage or missing parts. Drive the machine to check the steering linkage for damage. Hydraulic System Start the engine and allow it to idle for a few minutes. Drive the machine around for 2 – 3 minutes. Raise and lower the boom 2 – 3 times. Crowd and dump the bucket 2 – 3 times. This will circulate the hydraulic fluid through all hydraulic systems. Lubrication Perform all the daily maintenance procedures listed in this section (Section 3.) Grease all grease fittings in the steering linkage. Apply a coating of light oil to all exposed cylinder rods.
Apply a coating of light oil to all control linkages and all control valve spools. Check the condition of the oil coating each month and add to the coating where necessary. Battery Disconnect the cables from the battery, or remove the battery from the machine. If the battery is removed, fully charge the battery and store it. Cooling System Care If the cooling system does not need antifreeze and is filled with water only, add an anti-rust additive. If temperatures below freezing are expected, add antifreeze to protect the system to the level of cold expected. See antifreeze protection Table 4-1. Use a hydrometer to check the level of the antifreeze protection once each month.
If desired, the cooling system can be completely drained. If the system is drained, place a sign in the operator’s cab to warn the operator that there is no coolant in the engine. Air Tank Tap the brake pedal a few times to exhaust all of the air from the air tank. 3-28 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual