No Transmission Function at Any Engine Speed 4-6 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual Test Result Action 1. Check transmission fluid level. Level too low. Add oil to correct level. Level good. Go to Step 2. 2. Check mechanical connection between engine and torque converter. Defective. Repair. Connection good. Go to Step 3. 3. Perform transmission control pressure test. Pressure good. Go to Step 4. No pressure. Defective pump. Replace pump. 4. Test transmission controller current (use PR47). Test at switch outlet. Current good. Go to Step 5. No current. Damaged wire harness. Replace. Controller defective. Replace controller. 5. Physically damaged gearbox.
Replace gearbox. No Transmission Output in 1st and 2nd Gears Test Result Action 1. Test solenoid current out of controller (use PR47). Test all gears. No controller output current. Go to Step 2. Controller output current good. Go to Step 3. 2. Check current out of forward cut-off switch 1. No response. Defective cut-off switch or relay. Current from cut-off switch good. Defective controller. Replace controller. 3. Check current out of solenoid valves. No current output. Damaged solenoids. Replace solenoids.