OM2036 06/06 Safety - Section 20 Page 20-5 In The Operator’s Cab - Before Starting The Engine OPERATING THE MACHINE DO NOT leave tools or spare parts lying around or allow trash to accumulate in the cab of the truck. Keep all unauthorized reading material out of the truck cab. Starting The Engine DO NOT attempt to start the machine by shorting across the starter terminals. This may cause a fire, or serious injury or death, to anyone in the machine’s path. Keep the cab floor, controls, steps, and handrails free of oil, grease, snow, and excess dirt. Check for people and objects that remain on or around the truck. Check the seat belt, buckle, and hardware for damage or wear.
Replace any worn or damaged parts. Use the seat belts when operating a machine. DO NOT start the engine if a warning tag has been attached to the controls. Read and understand the contents of the Operation and Maintenance manual. Read the safety and operating instructions with special attention. Become thoroughly acquainted with all the gauges, instruments, and controls before operating the truck. When starting the engine, sound the horn as an alert. Start and operate the machine only while seated in the operator’s seat. DO NOT allow any unauthorized persons in the operator's compartment or any other place on the machine.
Read and understand the warning and caution decals in the operator's cab. Ensure the steering wheel, horn, controls, and pedals are free of any oil, grease, or mud. For machines equipped with a back-up alarm, check that the alarm works properly. Truck Operation - General Check the windshield wiper, the condition of the wiper blades, and the washer fluid reservoir level. Wear seat belts at all times. Be familiar with all steering and brake system controls, warning devices, road speeds, and loading capabilities before operating the truck. Only authorized persons are allowed to ride in the truck. Passengers must be in the cab and belted in the passenger seat.
DO NOT allow anyone to ride on the decks or on the steps of the truck. DO NOT allow anyone to get on or off the truck while it is in motion. DO NOT move the truck in or out of a building without a signal person present. Know and obey hand signal communications between the operator and spotter. When other machines and personnel are present, the operator must move in and out of buildings, loading areas, and through traffic, under the direction of a signal person. Courtesy at all times is a safety precaution! Immediately report any adverse conditions on the haul road, pit, or dump area that may cause an operating hazard.