E EMF14010 CLAMPING THE OUTBOARD MOTOR 1) Place the outboard on the transom so that it is positioned as close to the center as possible. Tighten the tran- som clamp screws evenly and secure- ly. Check the clamp-screws for tight- ness occasionally during operation of the motor as they can work loose due to engine vibration. 409011 w Loose clamp screws could allow the motor to move on the transom or fall off the transom. This could cause loss of control and serious injury. Make sure the transom screws are tightened securely. Occasionally check the screws for tight- ness during operation. 2) An engine restraint cable or chain should be used.
Attach one end to the engine restraint cable attachment point and the other to a secure mounting point on the boat. Other- wise, the engine could be completely lost if it accidentally falls off the tran- som. 410012 3-4