24. SERVICE PROCEDURE 24.8.4 REPLACE DRIVE TRAIN SYSTEM BREATHER REMARK To prevent dirt from entering the critical areas of the transmission system, keep the breather clean. Replace the breather as indicated by 23. MAINTE- NANCE SCHEDULE CHART. The breather is located on the transmission system filler tube. Unscrew the breather from the reducer nipple. Install the new breather on the nipple. 24.8.5 REPLACING DRIVE TRAIN PRESSURE FILTER REMARK If the pressure filter indicator light on the instrument panel, remains on at operating oil temperature with the engine running, the pressure filter must be changed. 1.
With the engine stopped, operate the transmission/steering lever several times to relieve any pressure. Open the battery box side door. Remove all outside dirt from filter. Using a filter wrench remove the spin on filter. Wipe the filter base, removing all of the old oil from the seal area. 2. Coat the seal (1) on the new filter (2) with clean oil. Install the filter by threading it onto the filter base (3) until the seal contacts the base, turn the filter by hand an additional % to % turn. 3. Check the level in the drive train system. REMARK Do not over-tighten the filter or use any tools for installation because this can damage the gasket and filter.
REMARK Mechanical over-tightening may distort the filter header threads or damage the element seal. 3-44