Komatsu — 24.10 PERIODIC

24. SERVICE PROCEDURE 24.1053 UNDERFLOOR LINKAGE Apply grease until clean lubricant is visible. Always use a clean lubricator and wipe dirt from fittings before fresh grease is applied. If grease fails to go through the fitting, determine the cause and correct it. After greasing, wipe off any old grease that was purged. I A WARN’NG - Seat belt - do not clean with solvents or bleach or redye color of webbing as this may cause a severe loss of strength. This could cause the webbing to break and result in personal injury. Wash in warm water with a mild detergent. 24.10.6 SEAT BELT Keep the belt flat to avoid twisting and roping when not being used.

Do not place heavy or sharp objects on the belt. The entire seat belt assembly should be inspected periodically for corrosion, wear, fraying or wear spots. The seat belt mounting bolts should also be periodically inspected for tightness. 3-55