9. Inspect rims. OPERATION Check the rims (wheels) and rings to confirm that there is no deformation, or damage caused by corrosion or cracks. In particular, check the side rings, lock rings, and rim flanges thoroughly. If any problem is found, replace the part. 10. Check for loose battery terminals. Tighten any loose terminal. Tightening torque: Portion A: . . . . . . . . . . . . . . . . . . . 5.9 – 9.8 N•m (52.2 – 86.7 lbf in) Portion B: . . . . . . . . . . . . . . . . . . 11.8 – 19.6 N•m (8.7 – 14.5 lbf ft) 11. Check for loose air cleaner mounting bolts. Check for loose bolts. Tighten any loose bolts. 12. Clean the cab window.
To ensure good visibility through the cab window during operations, always keep the glass clean. When cleaning the cab glass, use the handrail and step, and always be sure to maintain three-point contact (two feet and one hand, or one foot and two hands) with the handrail and step to ensure that your body is supported properly. See “Precautions When Cleaning Cab Glass” on page 1-20. 13. Check rear view mirror, underview mirror. Check that the mirrors are not damaged. Replace them if they are damaged. Clean the surface of the mirrors and adjust the angle so that the operator can see the area to the rear and under the machine from the operator's seat.
When cleaning the mirrors, use a mop with a long handle. 14. Check for damage and loose bolts on the handrail and steps. Repair any damage and tighten any loose bolts. 15. Check for damage to gauges, lamps on the instrument panel, and loose bolts. Check for damage to the panel, gauges, and lamps. If there is a problem, replace the parts. Clean off any dirt on the surface. Tighten any loose bolts. WA250-6 2-75