Komatsu — Normal Operation

3. Operate the work equipment control lever (3) to the TILT position (e) and return it to the HOLD position (b) to warm up the hydraulic oil. OPERATION The relief time at the TILT position (e) should be a maximum of ten seconds. This brings the oil to the relief pressure and warms the oil more quickly. 4. Slowly operate the steering wheel to the left and the right about ten times to warm up the hydraulic oil inside the steering valve. If the steering wheel is operated and stopped while the oil temperature is low, there may be a time lag before the machine stops turning. In this case, use the frame lock bar to ensure safety, and perform the warm-up operation in a wide place.

Do not relieve the hydraulic oil in the circuit continuously for more than five seconds. Remark Turn the steering wheel a little and stop in that position. Confirm that the machine turns by an angle equivalent to the amount that the steering wheel is turned. 5. After carrying out the warming-up operation, check that the meters, gauges, and pilot lamps work properly. If any abnormality is found, carry out maintenance or repair. 6. Run the engine under a light load until engine coolant temperature gauge (4) and HST oil temperature gauge (5) are in the white range. 7. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor.

WA250-6 2-97