Check Oil Level in Hydraulic Tank, Add Oil MAINTENANCE The parts and oil are very hot immediately after stopping the engine, and may cause burns. Wait for the temperature to decrease before starting the work. When removing the oil filler cap, turn it slowly to release any internal pressure and then remove it. 1. Park the machine on a level surface; lower the bucket to the ground; stop the engine; and wait for approximately five minutes. 2. Check the oil level with sight gauge (G). The oil level should be between the H and L marks. 3. If the oil level is above the H level, drain the excess oil from the drain plug (P).
Using the machine with excess oil in the circuit will damage the hydraulic circuit or cause the oil to spurt out. 4. If the oil is below the L mark, add oil to the hydraulic tank. A. Remove cover (1). B. Keep grip (2) pulled, then turn the cap of oil filler (F) counterclockwise and remove it. C. Add oil through oil filler port (F). D. After adding oil, install the cap of oil filler (F). E. Replace the cover (1). WA250-6 3-59