MAINTENANCE 9. Install the filter cartridge to the filter holder. When installing the filter cartridge, tighten until the packing surface contacts the seal surface of the filter holder and then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged; this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will leak from the packing. Always tighten the filter cartridge the correct amount. When tightening with a filter wrench, be extremely careful not to dent or damage the filter. 10. After replacing the fuel main filter cartridge, bleed the air from the system. For details, see the procedure on this page. 11.
After bleeding the air from the system, start the engine and check that there is no leakage of fuel from the filter seal surface. If there is still leakage of fuel, return to the Replace Fuel Main Filter Cartridge procedure and follow Steps 1 - 5 to remove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the cartridge with a new part, then repeat Steps 6 - 10 to install the filter cartridge. If there is any leakage of fuel, check the tightening of the filter cartridge. Bleeding Air from Fuel Line 1. Fill the fuel tank with fuel. Fuel capacity: . . . . . . . . . . . . . . . . . . . . . .
186 liters (49.14 US gal) 2. Open the engine side cover on the right side of the chassis. 3. Loosen and pull out feed pump knob (1) and move it forward and backward. The plug on the side surface of the fuel pre-filter head does not need to be removed. Keep moving knob (1) until it becomes heavy. 4. After bleeding air, push in and tighten knob (1). 5. Close the engine side cover on the right side of the machine. 3-74 WA250-6