Komatsu — Change Oil in Hydraulic Tank, Replace Hydraulic Filter Element

MAINTENANCE 11. Run the engine at low idle, and extend and retract the steering, bucket, and lift arm cylinders four to five times. Be careful not to operate the cylinder to the end of its stroke (stop approximately 100 mm (3.9 in) before the end of stroke). Remark If the engine is run at high speed immediately after startup or a cylinder is pushed up to its stroke end, air taken inside the cylinder may cause damage to the piston packing. 12. Operate the steering, bucket, and lift arm cylinders to the end of their stroke three to four times. Then stop the engine and loosen the filter cap to bleed the air from the hydraulic tank. 13.

Check the level of the hydraulic oil and add oil to the specified level. For details, see “Check Oil Level in Hydraulic Tank, Add Oil” on page 3-59. 14. Increase the engine speed and repeat the procedure in Step 11 to bleed the air. Continue this operation until no more air comes out. 15. After the bleeding air process has been completed, install covers (1) and (2). 3-78 WA250-6