Komatsu — Clean Brake Circuit Strainer

Clean Brake Circuit Strainer MAINTENANCE After the engine is stopped, the parts and oil are at high temperature and may cause burns. Wait for the temperature to go down before starting the operation. When the rubber hose is removed, oil may spurt out, so turn it slowly to release the internal pressure, then remove it carefully. Required Container to catch oil (300 cc volume) 1. Set the parking brake switch to the LOCK position. 2. Lower the work equipment to the ground; stop the engine; and wait for the temperature of all parts to go down. 3. Remove the cover under the floor frame at the left side of machine. 4. When rubber hose (1) and flange (2) are removed, oil will spill out.

Set the container in position to catch the oil. 5. Remove rubber hose (1) and flange (2). 6. Remove strainer (3) and wash it in clean diesel oil. 7. Assemble strainer (3) in strainer case (4) with the strainer protrusion side (O-ring side) facing the front and fix it with flange (2). 8. Install rubber hose (1). 9. Install the cover. WA250-6 3-83