. OPERATION OPERATION CAUTION belt conveyor. Pay 1) In case the belt is deflected or makes a snaky movement; Adjust the position of the take-up unit, referring to the figure at right. The take-up unit consists of a base plate, a pillow block and a tap bolt. Loosen the lock bolt on the base plate and adjust the position of the take-up unit with the tap bolt.After the adjustment, tighten the lock bolt again. When there is a clearance more than 10 mm (0.4 in) at both ends from the inner surface of the flange at the end of the pulley, the belt is at a proper position. 2) In case the belt tension is not appropriate; Adjust the belt tension in the same way as mentioned above.
At that time, adjust the belt so that it will have a clearance of 30 to 40 mm (1.2 to 1.6 in) from the lower surface of the magnet on the main body. 3) In case debris are stuck at the backside of the belt; Remove them as soon as found, since they can cause a damage on the belt or the pulley. 4) If the belt or any related part is broken, replace it immediately. 3 - 61 When conduction a trial run of the m achine, be sure to run the motor at low speed and check that the conveyor belt does not make a snaky movement. If metal pieces are drawn by the ma gnetic separator, they will be ejected, accelerated by the metal pie ce discharging belt.
As that poses a big danger, provide a s afety cover at the discharging outlet to prevent the metal pieces The discharging belt for this mac hine has the same structure as that for the conventiona attention to the following points, w hen starting the day's work or daily inspection. it make a snaky movement? of the belt? ched or peeled off? amaged? Has the belt been biased or doe Is the belt tension appropriate? Are debris stuck to the backside Has the belt surface been scrat Has the belt scraper not been d Have metal parts or or bolts at t he connetion of the belt end not been damaged or fallen If anything unusual is found, take t