Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION OPERATION OPERATION (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) Protector bolt Protector Cheek plate Fixed jaw plate wedge bolt Front frame Fixed jaw plate Crushing chamber Swing jaw plate Swing jaw Toggle seat Toggle plate Fixed link (13) (14) (15) (16) (17) (18) (19) (20) (21) (22) (23) Toggle seat Tension spring Lock cylinder Crusher motor Movable tooth wedge bolt V-belt Bearing cap tightening bolt Swing jaw Tension spring set length Tension rod Remote greasing point Check whether there are any foreign materials in the crusher chamber. Check that each bolt is tightened sufficiently.

Particularly check the main body securing bolts, toggle tension bolts of the toggle block, and wedge bolts of the fixed jaw and swing jaw with an extra care. Check that the crusher rotates in the right direction. Check that the spring set length is proper. The right spring set length is as indicated below. When measuring the tension spring set length, make sure that measurement is made at four points 90 ° apart from each other on the periphery and that the spring is upright. If the actual spring set length is longer than the specified dimension by more than 3 mm (0.118 in), turn the spring to change the spring seat and tighten it again. 3 - 64